Poulan 530163467 Bedienungsanleitung PDF herunterladen (Seite 9)

9

S Watch out for springpoles. Springpoles are

small size limbs which can catch the chain

and whip toward you or pull you off balance.

Use extreme caution when cutting small size

limbs or slender material.

S W atch out for branches immediately behind

the branch being pruned. If the chain hits

the rear branch, damage to the unit may oc-

cur.

S Be alert for springback. Watch out for

branches that are bent or under pressure.

Avoid being struck by the branch or the

pruner when the tension in the wood fibers

is released.

S Keep a clear work area. Frequently clear

branches out of the way to avoid tripping

over them.

S Long branches should be removed in sev-

eral pieces.

PRUNING TECHNIQUE

When ready to cut, accelerate to full throttle

and apply a light cutting pressure. DO NOT

use back and forth sawing action.

Pruning technique

Second cut

Third cut

Collar

First cut

1. Make the first cut 6 inches from the tree

trunk on the bottom of the limb. Use top of

guide bar to make this cut. Cut 1/3

through the diameter of the limb.

NOTE: When making the second and third

cuts, rest the foot of the pruner against the

tree limb that is being cut to prevent whipping

of the branch.

Foot

2. Next, move 2 -- 4 inches farther out on the

limb and make a second cut all the way

through the limb.

3. Then, make a final cut leaving a 1 -- 2 inch

collar from the trunk of the tree to avoid

damage to the tree.

MAINTENANCE

WARNING: Always stop unit and dis-

connect spark plug wire (or disconnect pow-

erhead from power source) before performing

maintenance.

CHECK FOR DAMAGED OR

WORN PARTS

Contact an authorized service dealer for re-

placement of damaged or worn parts.

S Oil tank -- Discontinue use of pruner attach-

ment if oil tank shows signs of damage or

leaks.

CHECK FOR LOOSE

FASTENERS AND PARTS

S Bar clamp nut

S Fasteners

INSPECT AND CLEAN UNIT AND

DECALS

S After each use, inspect complete unit for

loose or damaged parts. Clean the unit and

decals using a damp cloth with a mild deter-

gent.

S Wipe off unit with a clean dry cloth.

CHECK CHAIN TENSION

WARNING: Wear protective gloves

when handling chain. The chain is sharp and

can cut you even when it is not moving. Make

chain adjustments with lower end supported.

Chain tension is very important. Chains

stretch during use. This is especially true dur-

ing the first few times you use your pruner . Al-

ways check chain tension each time you use

and refuel your unit.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare