Poulan Saw V28 Bedienungsanleitung PDF herunterladen (Seite 4)

6 7

16

15

13

18

14

17

FUNCTIONAL DESCRIPTION

8

7

6

5

4

3

1

11

2

9

10

12

22

19

21

20

1. Front handle

2. Lock-off button

3. Trigger

4. Handle

5. Battery release buttons

6. Battery pack

7. Shoe

8. Lower guard lever

9. Lower guard

10. Blade bolt

11. Blade ﬂ ange

12. Blade

13. Wrench

14. Bevel pointer

15. Bevel adjusting knob

16. Bevel scale

17. Rip fence adjusting knob

18. Depth adjusting lever

19. Upper guard

20. Rip fence slot

21. Sight line

22. Spindle lock button

WARNING

TOOL ASSEMBLY

To reduce the risk of injury, always

remove battery pack before chang-

ing or removing accessories. Only

use accessories speciﬁ cally recom-

mended for this tool. Others may be

hazardous.

Selecting Blade

Always use sharp blades. Dull blades tend

to overload the tool and increase the chance

of KICKBACK (see "Causes and Operator

Prevention of KICKBACK"). Only use thin

kerf blades with a maximum safe operating

speed greater than the no load RPM marked

on the tool's nameplate. Read the blade

manufacturer's instructions before use. Do

not use any type of abrasive cut-off wheel

or dry diamond cutting blades.

Removing Battery Pack from Tool

Push in the release buttons and pull the

battery pack away from the tool.

Inserting Battery Pack into Tool

To insert the battery pack onto the tool, slide

the pack onto the body of the tool. Make sure

it latches securely into place.

Installing and Removing Blades

1. REMOVE BATTERY PACK BE-

FORE INSTALLING OR REMOVING

BLADES.

2. Place the saw on a ﬂ at surface with the

blade facing upwards. To remove the bolt

from the spindle, push in the spindle lock

button. While holding in the spindle lock

button, use the wrench provided with

the tool to turn the bolt clockwise (Fig.

2). Remove the bolt and blade ﬂ ange.

Fig. 2

3. Slide the lower guard lever up to raise

the lower guard. Remove the blade from

the spindle. Always clean the spindle,

upper guard and lower guard to remove

any dirt and sawdust.

NOTE: Do not remove inner blade

ﬂ ange. Larger diameter of inner ﬂ ange

(Fig. 3) should face the blade.

Fig. 1

Inserting a

battery pack

Removing a

battery pack

Bolt

Outer ﬂ ange

Inner ﬂ ange

Spindle

Fig. 3

4. To install a blade, place the blade on

the spindle with the teeth pointing in

the same direction as the arrow on the

lower guard (Fig. 4). Release the lower

guard lever.

Fig. 4

5. Place the blade ﬂ ange on the spindle

and hand tighten the bolt.

6. While holding in the spindle lock button,

use the wrench to turn the bolt counter-

clockwise and tighten.

WARNING

Recharge only with the charger

speciﬁ ed for the battery pack. For

speciﬁ c charging instructions, read

the operator's manual supplied with

your charger and battery pack.

1 2 3 4 5 6 7 8 9 ... 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare